Debugger
When a test does something you don’t understand, debug it: run it step by step and look at the app between steps.
- Click Debug on a test (or press F5). It runs to the first breakpoint.
- Tick Pause at the first step to stop before anything happens.
- Click a step’s number to set a breakpoint. Breakpoints are listed in the side panel’s Breakpoints tab, where you can switch them off or remove them. A breakpoint inside a flow stops every test that calls it.
While paused
Section titled “While paused”| Action | Key | Does |
|---|---|---|
| Continue | F5 | Run to the next breakpoint or the end |
| Pause | F6 | Stop at the next step |
| Step over | F10 | Run this step and stop before the next |
| Step into | F11 | Stop inside an if, each, repeat or flow |
| Step out | ⇧F11 | Finish the current block and stop after it |
| Run from here | Make any step in the current list the next one (also backwards) | |
| Stop | End the run |
Steps that ran show their result on the row. Inside a flow, a breadcrumb shows where you are.
Fix and carry on
Section titled “Fix and carry on”You can edit steps while paused. Edits are saved and used when you resume, so you don’t have to start over.
When a step fails, the debugger stops on it. Fix it in the editor and run it again from there, or continue to end the test. For a wrong selector, the failure’s suggestions are one click away: picking one replaces the selector in that step only.
Made by
© 2026 Bussin Bytes Ltd · sisyphus.bussinbytes.io
